Enabling Devices Palm Com

Features

• Enabling Devices Palm Com provides 10 seconds of recording time
• Excellent sound quality
• Small enough to fit in the pocket
• Belt clip, magnet, and key ring connector on back
• On/off switch
• Volume control
• Easy to record and re-record
• 1¼ inch activation area
• Size: 2 1/2" L x 4 3/4" W x 1 1/4" H
• Requires 3 AAA Batteries.

More Information

• Enabling Devices Palm Com Operation
  - The Palm Comm. requires 3 AAA batteries to operate (Not included)
  - Locate and remove the two Phillips Head screws on the top and bottom of the unit. Open the two halves of the unit to reveal the battery compartment. Observing polarity, install three AAA size batteries into the holder. Alkaline batteries must be used only (e.g. Duracell or Energizer brand). Do not use rechargeable batteries or any other type of batteries because they supply lower voltage and the unit will not perform properly. Re- assemble the two halves and replace screws
  - Turn the unit on by turning the ON/OFF/VOLUME knob (black knob) located on the side of the unit clockwise. You will hear an audible click when the unit turns on. Turn the knob half way to start and adjust as needed
  - To record, simply press and hold the red “RECORD” button with a pen and speak the message. Mouth should be about 6 inches from the microphone when recording (the Microphone is the “fuzzy” black circle on the side of the unit). Release the record button after recording
  - To play back the message, simply activate the round switch plate on the front of the unit. It is not necessary to continue holding the plate switch when listening to the message. The unit will continue to playback the entire message
  - The unit will retain recorded information indefinitely, even if the batteries are disconnected. Previously stored information will be erased only when a new recording is performed
  - The Palm Comm has removable 2" x 2" icon holder for placing Icons or Pictures
• Additional Features
  - It has a belt clip attached to the back of the unit which can be used on most belts
  - It has a magnet on the back which makes it easy to adhere to anything metal
  - It comes with a 1 inch key ring and wall connector so you can screw the ring to a wall and easily slip palm communicator on and off the wall
• Troubleshooting
  - Problem: The unit fails to operate, or operates incorrectly
  - Action 1: Disconnect the power by removing one of the batteries for 20 seconds in order to reset the unit. Re-install the batteries. If the unit does not work correctly, replace all the batteries paying careful attention to proper polarity
  - Action 2: Make sure that the unit is turned on and the volume turned up to an audible volume
  - Action 3: Make sure to depress record button while recording
  - Action 4: Make sure that there is nothing covering the Microphone
  - Problem: The unit is playing old messages fine, but will not record new messages
  - Action 1: Check batteries – There is a 99 percent chance that either one is installed incorrectly and/or one is weak/dead
• Care of the Unit: The Palm Comm. can be wiped clean with any mild household multi-purpose, non- abrasive cleaner and disinfectant. We recommend Simple Green, which is a non toxic biodegradable all-purpose cleaner. Do not use abrasive cleaners, as they will scratch the surface of the unit. Do not submerge the unit, as it will damage the electrical components.