Cybertech Minerva Cervical Thoracic Orthosis

More On Minerva Cervical Thoracic Orthosis

• Logroll patient to one side assuring that the head and neck position is maintained.
• Place posterior thoracic and occipital component into position. Loosen adjustment knobs then position components to desired location and retighten
• Uprights may be shaped by bending over bed rail if necessary. Posterior thoracic component: Fit to clear inferior angle of scapula. Occipital component: Should be placed for maximum total contact by shaping aluminum spine element.
• Logroll patient back to supine. Place anterior thoracic/chin piece component in place. Loosen knobs and position components to desired location and retighten. Engage cervical straps and adjust as necessary and tighten knobs. Apply strap stops.
• Adjust thoracic belt circumference, remove alligator hook and loop fastener clip and trim excess. This may be facilitated with quick release buckle in place. Attach forehead strap with inferior edge placed approximately 1 cm superior to eyebrows.
• Adjust upright as necessary and tighten knobs.
• Superior edge flairs should be fit at sub-costal margin.
  NOTE: After all adjustments have been made, it is recommended that the brace is removed and Loctite 414 applied using all precautions necessary.
  
  

• Remove the rigid components.
• The rigid components can be wiped clean with a damp cloth.
• Softgoods can be hand washed in warm water (90°F - 110°F or 32°C - 43°C) with mild detergent.
• Triple rinse, squeeze and air dry.
• Avoid twisting the material to remove water.
  

Minerva Cervical Thoracic Orthosis Specification

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 4+ 5 =   SubmitCancel

Enter your Answer below.

Security Question:4 + 5 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.