- How to use:
- Move volume switch to Low or Hi (85 dB or 100 dB), depending on required alarm volume for environment
- Select alarm tone, alarm or chime
- Select delay setting, 0-seconds or 2-seconds
- Switches are located inside battery compartment
- Plug sensor pad, lap cushion or seat belt into telephone-type jack on top of alarm box
- Inspect wires for damage before connecting
- Replace if damage to wiring or device is present
- Once initial pressure or contact is detected by alarm unit, unit will beep once to alert caregiver that unit is active
- If resident leaves the chair or bed, or unbuckles the seat belt, alarm will sound and LED will flash
- Unit will sound continuously until patient returns to bed or chair, or power switch is moved to the OFF position
- For lap cushion, unit will sound continuously until activation strap is properly re-secured or power is turned off
- Seat belt will continue to sound until buckled or power switch is turned OFF
- Caution:
- Battery power is low if LED flashes continuously and sounds a single beep every 30 seconds, so replace battery immediately
- If alarm tone decreases in volume, replace battery immediately
|
866-316-0162
